ISO/TS 23148:2024
(Main)Compatibility of lubricants with synthetic male condoms
Compatibility of lubricants with synthetic male condoms
This document provides guidance on assessing the effect or compatibility of an additional or personal lubricant with synthetic male condoms (excluding synthetic polyisoprene condoms). It also applies to topical medicines and any other substances that come into contact with such condoms. It describes the measurement of changes in physical properties of the condoms after exposure to the test substance (i.e. lubricant, topical medicine, etc.) and specifies the pass/fail criteria for such changes. This document is intended to be used for evaluating the compatibility of chosen additional lubricants or topical medicines with chosen synthetic condoms. Each lubricant type is evaluated specifically against each condom material for which compatibility is claimed. This document is not applicable to the assessment of the compatibility of lubricants applied to a condom at the time of manufacture. It is not directly applicable to female condoms, although similar principles can apply.
Compatibilité des lubrifiants avec les préservatifs masculins en matière synthétique
General Information
Buy Standard
Standards Content (Sample)
Technical
Specification
ISO/TS 23148
First edition
Compatibility of lubricants with
2024-03
synthetic male condoms
Compatibilité des lubrifiants avec les préservatifs masculins en
matière synthétique
Reference number
ISO/TS 23148:2024(en) © ISO 2024
---------------------- Page: 1 ----------------------
ISO/TS 23148:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
© ISO 2024 – All rights reserved
ii
---------------------- Page: 2 ----------------------
ISO/TS 23148:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Apparatus . 3
6 Materials . 4
7 Samples and tests . 4
7.1 Sample overview .4
7.2 Condom sample groups .5
7.3 Sample size .5
7.4 Quantity of test substance .5
7.4.1 Inflation testing .5
7.4.2 Tensile testing .5
8 Procedure . 5
8.1 General .5
8.2 Negative o
...
FINAL
TECHNICAL ISO/DTS
DRAFT
SPECIFICATION 23148
ISO/TC 157
Additional lubricants for male
Secretariat: DSM
synthetic condoms — Effect on
Voting begins on:
2023-03-30 condom strength
Voting terminates on:
Lubrifiants supplémentaires pour les préservatifs masculins
2023-05-25
synthétiques — Effet sur la résistance du préservatif
RECIPIENTS OF THIS DRAFT ARE INVITED TO
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
DOCUMENTATION.
IN ADDITION TO THEIR EVALUATION AS
Reference number
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
ISO/DTS 23148:2023(E)
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS. © ISO 2023
---------------------- Page: 1 ----------------------
ISO/DTS 23148:2023(E)
FINAL
TECHNICAL ISO/DTS
DRAFT
SPECIFICATION 23148
ISO/TC 157
Additional lubricants for male
Secretariat: DSM
synthetic condoms — Effect on
Voting begins on:
condom strength
Voting terminates on:
Lubrifiants supplémentaires pour les préservatifs masculins
synthétiques – Effet sur la résistance du préservatif
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
RECIPIENTS OF THIS DRAFT ARE INVITED TO
ISO copyright office
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
CP 401 • Ch. de Blandonnet 8
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
CH-1214 Vernier, Geneva
DOCUMENTATION.
Phone: +41 22 749 01 11
IN ADDITION TO THEIR EVALUATION AS
Reference number
Email: copyright@iso.org
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO
ISO/DTS 23148:2023(E)
Website: www.iso.org
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
Published in Switzerland
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN
DARDS TO WHICH REFERENCE MAY BE MADE IN
ii
© ISO 2023 – All rights reserved
NATIONAL REGULATIONS. © ISO 2023
---------------------- Page: 2 ----------------------
ISO/DTS 23148:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Apparatus . 3
6 Materials . 4
7 Samples and tests .5
7.1 Sample overview . 5
7.2 Condom sample groups .
...
Style Definition
...
Style Definition
...
ISO/DTS 23148:2023 (E)
Style Definition
...
ISO TC157/WG 15
Style Definition
...
Style Definition
...
Secretariat: DSM
Style Definition
...
Date: 2023-02-2103-15
Style Definition
...
Style Definition
Additional lubricants for male synthetic condoms — Effect on condom strength .
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
DTS stage
Style Definition
...
Style Definition
.
Style Definition
...
Warning for WDs and CDs
Style Definition
...
This document is not an ISO International Standard. It is distributed for review and comment. It is subject to
Style Definition
...
change without notice and may not be referred to as an International Standard.
Style Definition
...
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of
Style Definition
...
which they are aware and to provide supporting documentation.
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Style Definition
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
Formatted
...
---------------------- Page: 1 ----------------------
ISO/DTS 23148:2023(E)
Formatted: Font: 11 pt
© ISO 2023
Formatted: Font: 10 pt, Font color: Black, English
(United States)
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of
Formatted: Font color: Blue
this publication may be reproduced or utilized otherwise in any form or by any means, electronic or
mechanical, including photocopying, or posting on the internet or an intranet, without prior written Formatted: Font color: Black, English (United States)
permission. Permission can be requested from either ISO at the address below or ISO’sISO's member body in
Formatted: Font color: Black, English (United States)
the country of the requester.
Formatted: Font: 11 pt, Font color: Blue
ISO copyright officeCopyright Office
Formatted: Font color: Black, English (United States)
CP 401 • Ch. de Blandonnet 8
Formatted: Font: 11 pt, Font color: Blue
CH-1214 Vernier, Geneva
Phone: + 41 22 749 01 11
Formatted: Font color: Black, English (United States)
Email: copyright@iso.org
Formatted: Font color: Black, English (United States)
Email: copyright@iso.org
Formatted: Indent: Left: 0.5 cm, First line: 0 cm, Right:
Website: www.iso.orgwww.iso.org
0.5 cm, Adjust space between Latin and Asian text,
Published in Switzerland.
Adjust space between Asian text and numbers, Border:
Box: (Single solid line, Blue, 0.5 pt Line width)
Formatted: Font: 11 pt, Font color: Blue
Formatted: Font color: Black
Formatted: Font color: Black
Formatted: Font: 11 pt, Font color: Blue, English (United
Kingdom)
Formatted: Font color: Black
Formatted: Indent: Left: 0.5 cm, First line: 0 cm, Right:
0.5 cm, Space After: 0 pt, Adjust space between Latin
and Asian text, Adjust space between Asian text and
numbers, Border: Box: (Single solid line, Blue, 0.5 pt
Line width)
Formatted: Font color: Black
Formatted: Font color: Black, English (United States)
Formatted: Font: 11 pt, Font color: Blue, English (United
States)
ii © DTS 23148 – All rights reserved
ii © ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/DTS 23148:2023(E)
Formatted: Font: 11 pt
Contents
Foreword . v
Formatted: Font: Bold
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 2
5 Apparatus . 4
6 Materials .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.